DJI's industry leading flight control has never been so accessible. Flight Performance can be effected by mechanical performance and payloads.This is the DJI Naza-M Lite and GPS Combo Set.Naza-M Lite is not compatible with Naza-M V2 PMU or BEC/LED.Assistant Software System Requirement: Windows XP sp3 / Windows 7 / Windows 8.MAX: 1.5W Normal: 0.6W Operating Temperature: -10☌ ~ 50☌.Recommended Transmitter: PCM or 2.4GHz with minimum 4 channels.Supported ESC Output: 400Hz refresh frequency.Supported Multi-Rotor: Quad-rotor I4, X4 / Hex-rotor I6, X6, IY6, Y6.Remote Adjustment: The default parameter settings are OK for you to achieve a normal flight, and it also supports remote parameter adjustment by using a control slider on the transmitter during flight to obtain better performance.The system will adjust the gimbal and camera according to the attitude of the aircraft after setting the parameters the first time. Built-In Gimbal Stabilization Function: The gimbal stabilization module is compatible with almost all 2-axis gimbal systems.Quad I, Quad X Hexa I, Hexa V, Hexa Y, Hexa IY. Supported Multi-Rotor Types: Naza-M Lite supports six types of multi-rotor, to meet the different needs of the enthusiasts.Only one servo cable is used to connect the PPM or S-Bus to X2, this makes installation quick and easy, and helps to prevent mistakes. PPM & S-Bus receivers (the general use of the first 8 channels of S-Bus receiver) are used to optimize the channel connection, the A, E, T, R, U five-channel functions are set using channel X2. Supports Futaba S-Bus & PPM Receiver: Supports minimum Four channel receiver, and also supports PPM and Futaba S-Bus receivers.For more information, please refer to the user manual or DJI Wiki. Motor Disarm: There are two modes of Motor Disarm: Intelligent Mode and Immediate Mode. This enhances the safety of the multi-rotor no uncontrolled starting of the motors. During flight, if the motors stop, you can immediately execute the CSC command and the motors will start. When you want to start the multi-rotor, you must perform one of the CSC commands. Motor Arm & Motor Disarm: There are four ways to start the motors. In manual mode when low voltage protection is triggered, only the LED warning will be active. The first level will blink the red light continuously the second level will blink red light continuously and the multi-rotor will descend and land. Both levels of protection have LED warning as default. You can choose not to use this, however it is strongly recommended to enable the protection. Low Voltage Protection: In order to prevent your multi-rotor from crashing or other harmful consequences caused by low battery voltage, DJI has included two levels of low voltage protection.Mode by default without the failsafe function. If your using a 4 channel transmitter, then MC will work in Atti. If the GPS module is used, you can also set Return-to-Home on failsafe. Naza controller has built-in auto level failsafe function, which means when the communication between MC and the transmitter is disconnected, the outputs of all command sticks from controller will go to center position. Failsafe Mode: If your transmitter supports failsafe, then you can set failsafe through port-U.By using Intelligent Orientation Control (IOC), wherever the nose points,the forward direction has nothing to do with nose direction: In course lock flying, the forward direction is the same as a recorded nose direction. Intelligent Orientation Control (IOC): Typically, the forward direction of a flying multi-rotor is the same as the nose direction. Hovering accuracy is approximately 2.5m horizontal and 0.8m vertical. With the GPS Module, the multi-rotor will have position and altitude locked accurately even in windy conditions.
0 Comments
Leave a Reply. |